Anadex DP-9000 User Manual

•
•
•
•
•
•
•
•
SKIP-OVER-
PERFORATION
LINE
SPACING
LINE
WIDTH
CHARACTER
FONT
ALTERNATE
CHARACTER
TIME-OUT
AUTO LINE
FEED
TRUNCATE/
WRAPAROUND
- Switches S2-l and S2-2 establish the
desired perforation skip-over-distance
in ~ inch increments from 0 to l~ inches.
The sum of the switches in the ON posi-
tion represents the total skip-over-dis-
tance.
- SELECTION OF 6 or 8 lines per inch
vertical spacing is made by S2-4.
- Default selection of 8 inch or 13.2 inch
line width is made by S3-2.
- Regular or condensed characters are
selected by Sl-6.
- Selection of the if or'£ symbol is
available by Sl-8.
- A 7.5 second time-out feature is
selectable by Sl-7. When selected,
any unprinted and undetermined data
will be automatically printed with a
line feed after 7.5 seconds have
elapsed since receipt of the last
data entry. There is no time limit
when Sl-7 is OFF.
-
Switch S2-8 selects the Automatic
Line Feed feature. With the switch
ON, any line terminating code (CR,
FF, LF, or VT) will cause the data
line to be printed and one line feed
to be activated. With the switch OFF,
the CR will cause a line feed to be
scheduled at any time."
- Switch S2-7 selects the truncate/wrap-
around features. With the switch OFF,
the printer is in the wraparound mode,
and when a line contains more than the
number of characters programmed for line
length (8 or 13.2 inches deter-
mined by the position of S3-2 or
through the communications link) the
excess characters will be automatically
printed on the next line. With the
switch in the ON position, the excess
characters are truncated.
3-6

Anadex DP-9000 Specifications

General

Brand	Anadex
Model	DP-9000
Category	Printer
Language	English