A standard RS232 interface is available through a DB9 female connector:
- It permits controlling the device
- It permits updang the device
Data Rate: 1200 to 115200 Bauds, 8 data bits, 1 stop bit, no parity bit, no ow control by default.
DTR & RTS needed for rmware upgrade.
4.8
4.8.1 Serial interface
4.8.2.2 IP address
4.8.2 LAN interface
Availability
TCP Yes
UDP Yes
Availability
Stac user dened address Yes
A standard LAN interface is available through a RJ-45 connector
- It permits controlling the device
- It permits transferring conguraon
- It permits connecvity with the RCS² applicaon
- It permits updang the device
Default IP address: 192.168.2.140
The HDBaseT input and output connectors of the can manage the Ethernet
passthrough. A specic LAN over HDBaseT connector is available on the QuickMatriX-H to be connected to
the dedicated network.
The HDBaseT LAN cannot be used to manage the device.
4.8.3 HDBaseT LAN interface
Associated to each HDBaseT output connectors, the 5-pin MCO connector can passthrough the one-way
InfraRed and the Bidireconal Serial RS232 signals to the HDBaseT output interface.
The pins #1 to #3 are used for the HDBaseT Serial RS232 connecon, respecvely for the transmission (TX),
the recepon (RX) and the Ground RS232 signals.
The pins #4 and #5 of the MCO connector are dedicated for the HDBaseT IR signal, respecvely for the
recepon (RX) and for the Ground signals.
Please note that some IR sensors could have a low power signal which could not be compable with the
expected IR input characteriscs of the Midra™. In case of issue, make sure to use professional IR controller.
4.8.4 IR and SERIAL HDBaseT interface
4.8 Communicaon specicaons
To Next Page
Loading...
Need help?
General
