8.2.15 Working with Mirror modes
the mirror mode can be acvated layer by layer thanks to the layers menu. Select the
chosen layer and go in the layer menu, then select the “Layer Copy Mode” menu. There are several mirror
posioning opons:
this mode is the standard Matrix mode, output #1 and #2 are independent.
Outputs #1 and #2 will be the same. All changes on output #1 will be aected to output #2.
Layers will have the same posion and size.
OUTPUT #1 OUTPUT #2
OUTPUT #1
OUTPUT #1OUTPUT #2 OUTPUT #2
Output #2 will be exactly the same as output #1 except the fact that the selected
layer will have its H posion ipped (standard Mirror mode).
OUTPUT #1
OUTPUT #1
OUTPUT #2
OUTPUT #2
NOTES:
• Remember to simplify the use of this feature, you need to manipulate Output #1. While in mirror mode,
Output #2 will follow.
• Every change on Output #2 will have an eect only on Output #2, but remember that if a change occurs on
Output #1 aer that, Output #2 will update automacally to match output 1.
To Next Page
Loading...
Need help?
General
