USER MANUAL DENTAL UNIT - QS4-451-01 / SD 300 Scandinavian
28
NORMAL USE
- To introduce cold water into the area of operation, press the left button on the handle.
- To introduce cold air into the area of operation, press the right button on the handle.
- To introduce a cold air and water spray, press both buttons on the handle simultaneously.
- To introduce warm water into the area of operation, turn the switch on the base of the
handle to the right (the green indicator will light up) and press the left button on the handle
(only on models 6F and L).
- To introduce warm air into the area of operation, turn the switch on the base of the handle
to the right and press the right button on the handle (only on models 6F and L).
- To introduce warm a water and air spray into the area of operation, turn the switch on the
base of the handle to the right and press the two buttons on the handle simultaneously
(only on models 5F, 6F and L).
Note: The function of the switch is to select between warm and cold functions. The water or air
is heated instantaneously upon use. For this reason, the handle can be left constantly in the
“on” position without causing any problems or danger.
CLEANING AND STERILISING
135º C
After each intervention, and to maximise hygiene standards, the syringe can be
cleaned and sterilised. This is done through the following phases:
- Remove the tip (by unscrewing it at the mouth-tip) and/or the complete
handle (pressing the button on the handle bottom upwards).
- Clean with a cloth to remove any dirt or stains.
- Place in the autoclave with the steam set at 135°C for 20 minutes.
MAINTENANCE
The unit requires no specific maintenance, except for the regular cleaning and sterilization
described above. Avoid all kinds of lubrication, since this can cause irreparable damage to the
syringe.
SURFACES AND COMPONENTS
The product contains no dangerous, toxic or harmful components, nor does it come into
contact with any such products during manufacture.
To Next Page
Loading...