1. Important safety instructions
It is important that you read all the instructions before installing or using this equipment; paying
particular attention to the statements following the symbols detailed below.
Danger:
Risk of electric shock, the control panel contains high voltages and installation work should be carried
out with power isolated.
Risk of electric shock, the installer is required to access the unit with power applied in order to set up
the system the installer should therefore be correctly trained before setting up the system.
If the equipment is not used in the manner specified by the manufacturer, the protection provided by
the equipment may be impaired.
Under no circumstances should additional holes be made in the enclosure.
This equipment is for indoor and outdoor use.
Caution: the mains terminal cover on the PCB must be replaced should it be removed prior to use.
Warning: this equipment must be earthed.
The BundGuard control panel must be provided with an Earth (Ground) to ensure correct and safe
operation. If the panel is not correctly earthed (grounded),
Andel Limited cannot guarantee correct operation of the system.
Warning: connection of peripherals should only be carried out once the mains supply has been isolated
by breaking the RCD contactor.
Warning: disconnect the mains supply before undertaking any maintenance work within the equipment.
Any unused cable entry point must be blanked off to prevent access using suitably rated IP65/66
blanking plug.
To Next Page
Loading...