12
ABNORMAL OPERATION
Any of the following are considered to be abnormal operation and may
require servicing by a qualified service technician:
- Burner flame with yellow tips.
- Sooty on pan bottom.
- Difficult burner ignition.
- Burners fail to remain lighted.
- Burner will flame out.
- Difficult on turning gas valves.
NOTES:
Check regularly the correct functioning of gas valves, thermostat and selector
switches. In case of abnormal functioning of these devices, you must
immediately call a qualified technical assistance service.
OVEN DOOR
TO REMOVE OVEN DOOR
1) Fully open the oven door.
2) Raise the U-clip over the hook on each of the hinges to the “locked”
position, see figure 8. This will prevent the hinge from snapping closed
when the door is removed.
3) Grasp the door by the sides toward the back. Raise the front of the door
several inches (there will be some spring resistance to overcome because
of the hinge being locked). When the front of the door is high enough, you
will be able to lift the hinges to clear the indents
4) Pull the hinges out of the slots in the oven front frame.
TO REPLACE THE OVEN DOOR
1) Grasp the sides of the door at the centre and inert the ends of the hinges
into the slots in the oven front frame as far as they will go, see figure 8.
2) With the door open all the way, lower the two locking clips.
3) Raise the oven door and make sure that it fits evenly with the front sides.
WARNING: Never release the U-clip levers when the door is off. Do not close
the hinges. Without the weight of the door, the powerful springs will snap the
hinges closed with great force.
To Next Page
Loading...