20
ELECTRICAL INSTALLATION
The Range requires a single-phase 240 VAC - 50 Hz 40 amps power supply
electrical connection.
Refer to the appliance data label for rating information.
House wiring and fusing must comply with AS/NZS 3000 Wiring Rules and
any other relevant regulations.
Important: This appliance must be properly earthed.
Electrical damage can occur if this appliance is incorrectly installed – any
such damage is not covered by the warranty.
GAS SUPPLY
In Australia, this appliance shall be installed only by authorised personnel and
in accordance with the manufacturer’s installation instructions, local gas fitting
regulations, municipal building codes, electrical wiring regulations, AS
5601/AG 601 - Gas Installations and any other statutory regulations.
A ½” BSP inlet connection is recommended. The gas supply line to the
appliance must be of adequate length to allow sufficient withdrawal of the
appliance for service or disconnection and be:
(a) annealed copper pipe; or
(b) a Limited Flexibility Connector complying with requirements of AG 216.
Be sure all control knobs are set in the OFF position prior to supplying gas to
the hob.
Test for gas leaks by approved method. NEVER CHECK FOR GAS LEAKS
WITH A FLAME.
BEFORE LEAVING
Check all connections for gas leaks with soap and water. DO NOT use a
naked flame for detecting leaks. Ignite all burners to ensure correct operation
of gas valves, burners and ignition. Turn gas taps to low flame position and
observe stability of the flame. When satisfied with the cooker, please instruct
the user on the correct method of operation. In case the appliance fails to
operate correctly after all checks have been carried out, please refer to
section below for contact details.”
To Next Page
Loading...