- 8 -
C139614000.fm
ES
FR
DE
GB
IT
English
The information provided below is intended to identify the alarm
signals provided by the malfunction alarm light (A) and the gas
alarm light (B).
Important
When handling and installing the appliance comply
with the information provided by the constructor di-
rectly on the packaging, on the appliance and in the
instructions for use. If necessary, the person author-
ised to carry out these operations must organise a
"safety plan" to protect the people directly involved.
The packaging is designed to reduce space and as appropriate
to the type of transport used.
To simplify transport, some components may be removed and
suitably protected and packed for transport.
The packaging carries all information necessary for loading and
unloading.
When unpacking, check that all components are present in the
correct quantities and are undamaged.
The packaging material must be properly disposed of in accord-
ance with legal requirements.
TABLE OF ALARM INDICATIONS
6/2
Alarm Fault Remedy Notes
Malfunction
alarm
Overload cutouts tripped Inform the after-sales service
The oven's functions are disabled
so no cooking cycles can be
carried out
Safety thermostat tripped Inform the after-sales service
The oven's functions are disabled
so no cooking cycles can be
carried out
Gas alarm
No mains gas, gas pressure too low or
flame detection failure
Turn the knob to the "RESET" setting (this
may have to be done several times); if the
problem persists inform the after-sales
service
Stop cooking if the light remains on
HANDLING AND INSTALLATION 7
RECOMMENDATIONS FOR
HANDLING AND INSTALLATION
7/1
PACKAGING AND UNPACKING
7/2
IDM-39614000400.tif
A
B
IDM-3960200170.tif
To Next Page
Loading...
Need help?
General
