1211
Leveling Heatbed
The heatbed calibration is the most important step for successful printing as it ensures
part adhesion on the rst layer. Ideally, the distance between the nozzle and the
heatbed is constant, but it varies at different positions, which could cause warping on
prints or even a complete failure.
Tear off the protective lms on the touch screen.
On the touch screen, follow the onscreen instructions to complete the leveling and
other operations.
Avoid moving the printer during the auto-leveling process.
You can tap
Skip
, but make sure to level the heatbed before the rst use.
Please set up the system in the AnkerMake app while waiting for leveling to nish.
Steady Green: Working
To Next Page
Loading...
