Page 8 of 24
5 Assembly Method
Please Note: Always remove the Battery Charger from the power socket
before assembly.
5.1 Charging / Storage Stand
The vacuum cleaner is supplied with a Charging / Storage stand and will
need to be assembled before use.
Place the base on a flat surface and take the stand post and insert one end
into the hole in the base as shown.
NOTE: The end of the tube has a slot cut out in it which needs to align with
the tab inside the base hole.
Once the slot is aligned, firmly push the tube inside the base hole until it is
fully inserted.
To Next Page
Loading...
