anko ST01 - Troubleshooting and Specifications; Common Troubleshooting Solutions; Vacuum Cleaner Specifications

11
TROUBLE SHOOTING
PROBLEM
POSSIBLE REASONS
POSSIBLE SOLUTIONS
VACUUM WILL
NOT OPERATE
No power. Check the mains
electrical power outlet
supplying power to the
vacuum cleaner.
Check the household fuse or circuit
breaker. Replace fuse/reset circuit
breaker.
VACUUM WILL
NOT PICK-UP
DEBRIS OR
SUCTION POWER
IS WEAK
1. Dust cup container full.
2. Dust cup filter needs
cleaning or
replacement.
1. Empty dust cup container.
2. Remove dust filter and check
for object(s) in the air duct and
remove. Clean or replace filter.
DUST ESCAPING
FROM VACUUM
1. Dust cup container is
full.
2. Dust cup filter is not
installed correctly.
3. Puncture/hole in the dust
cup filter.
1. Empty dust cup container.
2. Review dust cup filter
installation instructions.
3. Replace dust cup filter.
TECHNICAL SPECIFICATION
Voltage: 220-240V~ 50/60Hz
Power : 600W