Anolis ArcPower 384 - Fixture Information

18
Ethernet Settings --- The menu provides all needed settings for an Ethernet operation.
Set Ethernet Mode - use the menu to set an Ethernet functional mode:
Disable Ethernet - Disables an Ethernet operation.
Ethernet - control data is received to the Ethernet input of the xture ( RJ45 socket).
Each of xtures has to be connected to Ethernet.
Set IP Address - Select this menu item to set an IP address. The IP address is the
Internet protocol address, uniquely identies any node (xture) on a network.
There can‘t be 2 xtures with the same IP address on the network!
Default IP Address - a preset IP address, you can change only rst number of
the IP address (number 2 or 10).
Custom IP Address - a fully editable IP address.
To set the custom IP address:
1. Select the „Custom IP Address” and press the ENTER button
2. Use ANS wheel to adjust he rst number of the IP address
3. Press the ENTER button to move on the second number of the
IP address
4. Repeat steps 2 and 3 for the third and the fourth number of the
IP address.
If you want to return back on the previous number, press the ESC button.
Set ArtNet Universe - use this menu item to set a xture Universe. The Universe is a single
DMX 512 frame of 512 channels.
10.2 Fixture information
Use this menu to read useful information about the xture status.
Power On Time --- Use the menu item to read the number of operation hours.
Total Hours - the function shows the total number of the operation hours since
the ArcPower 384 Rack Mount has been fabricated.
Resettable Hours - the function shows the number of the operation hours that
the ArcPower 384 Rack Mount has been powered on since the counter was last reset.
In order to reset this counter to 0, press the ENTER button twice.
Air Filters --- Regular cleaning of the air lters is very important for the xture´s life and performance. Build-up
of dust, dirt and fog uid residues reduces the xture´s light output and cooling ability. The two items of this
menu help you to keep cleaning period of the air lters.
Set alert period - cleaning schedule for the xture depends on the operating environment.
It is therefore impossible to specify accurate cleaning interval. This function allows
you to change the cleaning interval of the air lters. This „alert“ value is 50 hours and it
is set as default. Inspect the xture within its 50 hours of operation to see whether cleaning
is necessary. If cleaning is required, clean all air lters and change the value in this menu
on acceptable level. Min. level of alert period is 10 hours, max. is 300 hours.
Elapsed Time - the option allows you to read the time which remains to cleaning air lters.
The time period is set in the menu mentioned above.
Expired time period is signalized by a negative mark at the time value and a warning icon
(triangle) on the display with the following message: „Clean Air Filters“.
Clean the lters and reset this menu item (by pressing the ENTER button twice while
this menu is highlighted) to start the new time countdown.
Fixture Temperatures --- Select this menu to read the temperatures of the xture:
Current - the current temperature of the xture inside.
Maximum nonresettable - the menu item shows the max. temperatures of the xture inside
since the ArcPower 384 Rack Mounthas been fabricated.
Maximum resettable - the menu item shows the maximum temperatures of the xture
inside since the counter was last reset. In order to reset desired counter to 0,press
the ENTER button twice.
Note: The ambient temperature should not exceed 40°C.
The temperatures can be displayed in either °C or °F units - see option „Temperature unit“ in the menu “Per-
sonality“.
Measuring temperature points: Board 1 Temp. - temperature on the electronic module 1.
Board 2 Temp. - temperature on the electronic module 2.