Anritsu 681XXC - Chapter 2 Installation; 2-1 INTRODUCTION; 2-2 INITIAL INSPECTION

Table of Contents
2-1 INTRODUCTION ...................2-3
2-2 INITIAL INSPECTION................2-3
2-3 PREPARATION FOR USE ..............2-4
Power Requirements...............2-4
Line Voltage Selection ..............2-4
Power Connection ................2-4
Standby Operation................2-5
Warmup Time ..................2-6
Operating Environment .............2-6
2-4 GPIB SETUP AND INTERCONNECTION .....2-7
Interface Connector ...............2-7
Cable Length Restrictions ............2-7
GPIB Interconnection ..............2-7
Setting the GPIB Address ............2-7
Selecting the Line Terminator ..........2-9
Selecting the Interface Language.........2-9
2-5 RACK MOUNTING KIT INSTALLATION .....2-10
Preliminary ..................2-10
Procedure ...................2-10
2-6 PREPARATION FOR STORAGE/SHIPMENT . . . 2-13
Preparation for Storage.............2-13
Preparation for Shipment............2-13
Chapter 2
Installation