Anritsu 681XXC - Selecting a Power Level Sweep Range

Selecting a
Power Level
Sweep Range
Selecting a power level sweep range consists of
choosing a start and stop level for the power level
sweep. The power level sweep range selection pro
-
cess is identical for all power level sweep modes
—CW power sweep, analog sweep frequency/step
power, and step sweep frequency/step power. You
can select a power level sweep range as follows:
q
Edit the current start and stop power level
parameter values.
q
Enter new start and stop power level parame
-
ter values.
q
Select one of the preset power level sweep
range parameters (L1-L2, L3-L4, L5-L6, L7-L8,
or L9-L0).
Editing the Current Start / Stop Power Levels
To edit the current power level sweep range, start
by opening either the start or stop power level pa
-
rameter (in the display above, Edit L1 opens the
start power level parameter; Edit L2 opens the stop
power level parameter).
Edit the open power level parameter using the cur
-
sor control key or the rotary data knob. When you
are finished, close the open parameter by pressing
its menu edit soft-key or by making another menu
selection.
Entering New Start / Stop Power Levels
To enter a new power level sweep range start by
opening either the start or stop power level parame
-
ters (press Edit L1 or Edit L2 ).
Enter a new power level using the keypad and ap
-
propriate terminator key. When you are finished,
close the open parameter by pressing its menu edit
soft-key or by making another menu selection.
3-56 681XXC OM
LOCAL (FRONT POWER LEVEL
PANEL) OPERATION SWEEP OPERATION
NOTE
When Linear power level sweep is
selected, use the following termina
-
torkeysforpowerleveldataentries:
GHz / Sec / dBm for V
MHz/ms/dBfor mV
kHz / ms / STEPS for mV