7-2 Opening the S412E Case Chapter 7 — Assembly Replacement
7-2 PN: 10580-00324 Rev. N S412E MM
2. Remove the top and bottom bumpers (Figure 7-1) to expose the screw holes on the back of the unit
Remove the nut and washer on the GPS Connector.
3. Place the S412E face down on a stable work surface that will not scratch the display.
4. Use a Phillips screwdriver to remove the six screws securing the two halves of the S412E case together
(Figure 7-2).
5. Carefully lift up on the side of the case indicated above and begin to separate the two halves.
Figure 7-1. Top Bumper and Option 31
Figure 7-2. Remove the Four Screws
Top Bumper
GPS Connnector
for Option 31
Carefully lift
this side first
Location of the 6 screws to remove.
To Next Page
Loading...
