Chapter 7 — EV-DO Commands 7-10 :TRACe Subsystem
MS2720T PM PN: 10580-00341 Rev. C 7-23
7-10 :TRACe Subsystem
This subsystem contains commands related to the transfer of trace data to and from the
instrument.
:TRACe:PREamble? <trace type>
Title: Trace Header Transfer
Description: Returns trace header information for the specified trace. The <trace
type> must be one of the following:
SPECtrum|EMISsion|CDPMac|CDPData|PSCAn|MPATh.
Data can be transferred to and from the 6 available display trace types.
Use the commands in the MMEMory subsystem to store and recall
traces from the instrument memory. The response begins with an
ASCII header. The header specifies the number of following bytes. It
looks like #AX, where A is the number of digits in X and X is the
number of bytes that follow the header.)
Parameters are returned in comma-delimited ASCII format. Each
parameter is returned as “NAME=VALUE[ UNITS],” Valid parameter
names are shown in “EVDO Parameter Names” on page 2-27.
Parameter: <trace type>
Related Command: :TRACe:DATA?
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
