Chapter 8 — WCDMA Commands 8-8 :MEASure Subsystem
MS2720T PM PN: 10580-00341 Rev. C 8-35
:MEASure:RF:SUMMary?
Title: Measure RF Summary
Description: Sets the active measurement to RF Summary, sets the default
measurement parameters, triggers a new measurement and returns
Carrier Frequency, Frequency Error, channel Power, P-CPICH Power,
Carrier Feed Through, Peak CDE, EVM, P-CCPCH Power, S-CCPCH
Power, PICH Power, PSCH Power, SSCH Power, RMS Phase Er (deg).
It is a combination of the following commands :CONFigure:RF
SUMMary and :READ:RF:SUMMary? To make a RF Summary
measurement with settings other than the default values send:
:CONFigure:RF SUMMary Commands to set desired settings
:READ:RF:SUMMary?
Data is returned as 10 comma-delimited values: Channel Power,
Carried Frequency, Frequency Error, Spectral Emission, Occupied
Bandwidth, Peak to Avg Power, Filtered –10MHz, Filtered –5 MHz,
Filtered 5MHz, Filtered 10 MHz. All invalid values are replaced with
“--”. Power units are in watt or dBm as per what is set by the user.
Frequency is always in Hz.
Related Command: :CONFigure:RF SUMMary
:READ:RF:SUMMary?
:FETCh:RF:SUMMary?
Front Panel
Access: Measurements, RF, RF Summary
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
