Chapter 10 — GSM Commands 10-10 [:SENSe] Subsystem
MS2720T PM PN: 10580-00341 Rev. C 10-19
10-10 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:FREQuency:BAND AUTO|GSM|EDGE
[:SENSe]:FREQuency:BAND?
Title: GSM/EDGE Measurement Selection
Description: This command toggles the type of signal that is measured. AUTO allows
the instrument to search for a GSM or EDGE signal automatically.
GSM sets the instrument to measure only GSM signals. EDGE sets the
instrument to measure only EDGE signals.
The query form of the command returns the measurement mode that
the instrument is currently in.
Parameter: AUTO|GSM|EDGE
Parameter Type: <char>
Default Value: AUTO
Front Panel
Access: Setup, GSM/EDGE Select
[:SENSe]:FREQuency:CENTer <freq>
[:SENSe]:FREQuency:CENTer?
Title: Center Frequency
Description: Sets the center frequency. Note that changing the value of the center
frequency will change the value of the coupled parameters Start
Frequency and Stop Frequency. It may also change the value of the
span.
Parameter: <freq>
Default Value: 1GHz
Default Unit: Hz
Range: 0Hz to 7.1GHz
Front Panel
Access: Freq, Center Freq
[:SENSe]:FREQuency:SIGStandard:CHANnel <number>
[:SENSe]:FREQuency:SIGStandard:CHANnel?
Title: Channel Selection
Description: Sets the channel number for the selected signal standard.
Parameter: <number>
Front Panel
Access: Freq, Channel
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
