MS2720T PM PN: 10580-00341 Rev. C 11-1
Chapter 11 — Fixed WiMAX
Commands
11-1 :ABORt Subsystem
The abort subsystem includes commands that allow the user to stop current measurement
activities on the instrument.
:ABORt
Title: Abort
Description: Restarts the current sweep and/or measurement. Resets the trigger
system. If :INITiate:CONTinuous is OFF (i.e. the instrument is in
single sweep mode), send the command :INITiate[:IMMediate] to
trigger the next sweep. If :INITiate:CONTinuous is ON (i.e. the
instrument is in continuous sweep mode) a new sweep will start
immediately.
Parameter: NA
Related Command: :INITiate:CONTinuous
:INITiate[:IMMediate]
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
