Chapter 11 — Fixed WiMAX Commands 11-10 [:SENSe] Subsystem
MS2720T PM PN: 10580-00341 Rev. C 11-23
11-10 [:SENSe] Subsystem
The commands in this subsystem relate to device-specific parameters, not signal-oriented
parameters.
[:SENSe]:BANDwidth|BWIDth[:RESolution] <index>
[:SENSe]:BANDwidth|BWIDth[:RESolution]?
Title: Resolution Bandwidth
Description: Sets the resolution bandwidth. The <index> argument is a 1-based
index of the position of the desired bandwidth in the instrument’s
current bandwidth list. The list can be seen on the instrument by
choosing the “BW” submenu button in the “Setup” menu. For example,
if the desired bandwidth is the 3rd item on the list then the value of the
<index> argument would be 3.
The query form of this command will return the index of the
currently-selected bandwidth on the list. The Default is the 1st index in
the bandwidth list.
Parameter: <index>
Default Value: The default bandwidth is 1.25MHz which is the 1st index in the
bandwidth list.
Front Panel
Access: Setup, BW
[:SENSe]:CPRatio <index>
[:SENSe]:CPRatio?
Title: Cyclic Prefix Ratio (G)
Description: Selects the desired Cyclic Prefix Ratio from the list. The <index>
argument is a 1-based index of the position of the desired CP Ratio in
the instrument’s current CP Ratio list. The list can be seen on the
instrument by choosing the “CP Ratio (G)” submenu button in the
“Setup” menu. For example, if the desired CP Ratio is the 3rd item on
the list then the value of the <index> argument would be 3.
The query form of this command will return the index of the
currently-selected CP Ratio on the list. The default CP ratio is the first
index in the CP ratio list.
Parameter: <index>
Default Value: The default CP Ratio is 1/4, which is the first index in the CP Ratio list.
Front Panel
Access: Setup, CP Ratio (G)
[:SENSe]:DEMod:CONStln:POINts?
Title: Number of Constellation Point
Description: Queries the number of Constellation points.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
