14-3 :CONFigure Subsystem Chapter 14 — TD-LTE Commands
14-6 PN: 10580-00341 Rev. C MS2720T PM
14-3 :CONFigure Subsystem
This set of commands prepares the instrument for the selected measurement. It disables any
currently-enabled measurements and activates the specified measurement. It sets the
instrument to single sweep mode, waiting for an :INITiate command. It will not initiate the
taking of a measurement.
Current instrument settings may be changed to default values. These changes are identified
with their respective measurement commands.
:CONFigure SUMMary
Title: Set Measurement to TD-LTE Summary
Description: Sets the measurement to TD-LTE Summary. It disables any other
active measurements. None of the instrument parameters are changed
by the execution of this command. (:INITiate:CONTinuous OFF).
Measurement settings can be modified by using the [:SENSe]
commands before initiating a measurement.
Parameter: SUMMary
Parameter Type: <char>
Front Panel
Access: Measurements, TD-LTE Summary
:CONFigure?
Title: Configure Query
Description: :CONFigure? query returns the name of the measurement previously
set up using a CONFigure command or a MEASure? query. The list
below shows the possible return values.
SUMM
RF,SPEC
RF,ACLR
RF,SEM
RF, PVT, SUBF
RF, PVT, FRAM
RF,SUMM
DEM,CONS
DEM,CCPG
DEM,CCPT
DEM,PVRB
DEM,SUMM
PF
OTA,OTAS
OTA,OTATX
OTA,MAP
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
