Anslut 013947 - Operating Modes

EN
79
Error codes
E1 Error on room temperature sensor.
E2
Error on evaporator temperature
sensor.
E3
Error on condenser temperature
sensor.
E4 Display communication error.
EC
Leakage of refrigerant detected (some
models).
Warning code
P1
The tank is full. Connect the drain
hose and drain o the water. Contact
the retailer if the fault persists.
NOTE:
If any of the above error codes are shown,
switch o the air conditioner and check for
any obstructions. Start the air conditioner.
Switch o the air conditioner and pull out the
plug if an error code is still shown. Contact an
authorised service centre or other qualied
personnel.
HOW TO USE
COOL (cooling mode)
1. Continue pressing the MODE button until
the COOL status light goes on.
2. Set the required room temperature (set
point temperature) with the + and -
buttons. The temperature can be set from
17 to 30°C or from 62 to 88°F (or 86°F).
3. Press the FAN SPEED button on the remote
control to set the fan speed.
FAN (fan only)
1. Continue pressing the MODE button until
the FAN status light goes on.
2. Press the FAN SPEED button on the
remote control to set the fan speed. It is
not possible to set the temperature.
3. Do not lead the hose through the window.
DRY (dehumidication)
IMPORTANT:
When the dehumidication function is not in
use, the drain plugs must be tted securely
in the outlets. When the dehumidication
function is in use, the drain plugs must be
stored out of the reach of children in order to
avoid the risk of choking.
1. Continue pressing the MODE button until
the DRY status light goes on.
2. In this mode it is not possible to adjust
the set point temperature or fan speed.
The fan motor runs at low speed. Keep
doors and windows closed for best
dehumidication function.
3. Do not lead the hose through the window.
AUTO
1. In AUTO mode the air conditioner runs
in cooling or only fan mode, depending
on the room temperature the set point
temperature.
2. The air conditioner automatically
maintains the room temperature close to
the set point temperature.
3. In AUTO mode it is not possible to set the
fan speed.
NOTE:
On some models both the status light for
AUTO mode and the status light for the actual
mode go on in AUTO mode.
SLEEP/ECO
Pressing this button increases (cooling mode)
or reduces (heating mode) the set temperature
by 1°C/2°F (or 1°F) after 30 minutes. After
another 30 minutes the set temperature
increases (cooling mode) or reduces (heating