AnyCubic MEGA ZERO - Page 36

Introduction to slicing software
Cura ? x
rc)
ri) Successfully imported profile Suggested parameters MEGA~ZERO-PLA-V1.0
=|
(3) Select the configuration file that you just imported.
Click to open
“Print settings”
Print settings x
©
Layer
Height
———————e—_
on
02 03
(2) infil (9)
2 4060
Gradual infill
&\ Support
+ Adhesion
Click to open the print
parameters interface
= Normal0.2mm 325% lon
Print settings ®
High - 0. Ina
Wormel - 0. 2am
Draft - 0.3an
Cooling
Support
Build Plate Adhesion
ik Dual Extrusion
32