Why does my AnyTone AT-5189 have a decreased communication range?
If you experience a drop in the communication range of your AnyTone Radio, consider the following: * Ensure the antenna connector is properly connected. * Verify that the radio is not operating in a low power mode; if it is, switch to a higher power level.
What to do if my AnyTone AT-5189 does not power on?
If your AnyTone Radio fails to power on (no display) after connecting to a 13.8 V DC power supply, check the following: 1. Ensure the DC power cable is correctly connected, with the red (+) and black (-) leads properly aligned. 2. Inspect the power cable fuses for any breaks. If a fuse is blown, identify the cause, correct the issue, and replace the fuse with one of the same rating.
Why is the AnyTone AT-5189 display dim even at high brightness?
If the display on your AnyTone Radio is too dim even at a high brightness setting, the supply voltage may be too low. Ensure the supply voltage is within the range of 11.7 V to 15.8 V DC (13.8 V DC ±15%). Adjust your regulated power supply and check all power cable connections if the input voltage is outside of the specified range.
What to do if I cannot transmit with my AnyTone AT-5189?
If you are unable to transmit using your AnyTone Radio, even when pressing the microphone PTT button, the microphone plug may not be fully inserted into the front panel connector. Turn off the power, then firmly insert the microphone plug until you hear the locking tab click into place.
Instructions for installing the transceiver in a vehicle.
Steps to connect the DC power cable to the vehicle's battery.
Instructions for setting up the transceiver for fixed station use.
Guidance on connecting an antenna for optimal performance.
Description of the transceiver's front panel controls and displays.
Details of the connectors on the rear panel of the transceiver.
Instructions on how to transmit using the microphone and PTT.
Steps to edit an existing channel's frequency or settings.
How to assign a name to a channel for easy identification.
Function to monitor a priority channel periodically.
Selecting wide or narrow bandwidth for transmission.
Skipping or scanning specific channels during scan.
How to copy channel data to another channel.
Switching between high, middle, and low transmit power.
Procedure to delete a selected channel from memory.
Setting up CTCSS or DCS codes for encoding transmission.
Setting up squelch mode based on signaling type.
Setting the frequency offset for repeater communication.
Enabling talk around for direct communication.
Setting up CTCSS or DCS codes for decoding reception.
Switching between transmit power levels.
Enabling or disabling voice prompts for status confirmation.
Preventing transmission on busy channels.
Setting pause duration for scan dwell time.
Displaying the current voltage of the transceiver.
Resetting the transceiver to factory default settings.
Setting a timer to prevent prolonged transmission.
To Next Page
General
