Why is there no sound coming from my AnyTone Radio speaker?
If no sound is coming from the speaker of your AnyTone Radio, it might be because the CTCSS/DCS squelch is active. Try turning the CTCSS or DCS squelch off to resolve this issue.
What to do if the keys and dial on my AnyTone AT-588 Radio don't work?
If the key and dial on your AnyTone Radio are not functioning, the key-lock function may be activated. To restore functionality, cancel the key-lock function.
How to brighten the display on my AnyTone AT-588?
If the display on your AnyTone Radio is too dim, adjust the dimmer setting to "LAMP-H".
What to do if the dial on my AnyTone Radio won't change the memory channel?
If the rotating dial on your AnyTone Radio will not change the memory channel, the transceiver might be in CALL mode. Press the VFO or memory mode button.
General| Operating Voltage | 13.8V DC ±15% |
|---|---|
| Weight | 1.2 kg |
| Channel Spacing | 12.5/25 kHz |
| Squelch | Carrier, CTCSS, DCS |
| Modulation | FM |
Guide for mounting the transceiver safely and conveniently inside a vehicle.
Instructions for connecting the transceiver to a 12V DC power source, ensuring correct polarity.
Procedures and precautions for replacing blown fuses in the transceiver and power cable.
Guidance on connecting an efficient antenna for optimal transceiver performance.
Configuration and operation for the transceiver in Amateur mode.
Configuration and operation for the transceiver in Professional mode.
Steps for turning the transceiver on/off and adjusting the audio volume level.
How to switch between Frequency (VFO) and Channel modes for operation.
Using controls to change frequency or select channels for communication.
Procedures for receiving signals and initiating transmissions using the transceiver.
How to set and adjust the squelch level for clear reception.
Using frequency or channel scan modes to monitor communication.
Configuring CTCSS tones and DCS codes for selective communication.
Scanning for CTCSS signals to find matching communication parameters.
Scanning for DCS signals to find matching communication parameters.
Resetting the transceiver to its original factory settings to resolve issues.
Switching between frequency and channel modes using the microphone.
Transmitting pre-programmed DTMF, 2-Tone, or 5-Tone codes quickly.
Guide to installing the necessary USB driver for the programming software.
Lists the factory default settings for both VHF and UHF operation modes.
Provides solutions for common problems and issues encountered with the transceiver.
To Next Page
