Need help?Do you have a question about the AnyTone AT-318UV and is the answer not in the manual?
General| Power Output | 5W / 1W |
|---|---|
| Operating Voltage | 7.4V |
| Mode | FM |
| Display | LCD |
| Waterproof | IP54 |
| Channel Capacity | 128 |
| Operating Mode | Simplex |
| Antenna Impedance | 50 ohms |
| Frequency Range | 136-174MHz / 400-480MHz |
Lists all items included in the transceiver package.
Details the items included as standard accessories.
Details optional accessories available for purchase.
Instructions on how to charge the battery for optimal performance.
Specifies the use of designated chargers to prevent damage.
Important warnings and tips for safe and effective battery charging.
Step-by-step guide on how to charge the transceiver's battery.
Instructions for attaching and detaching the battery pack.
Guide on how to securely attach and detach the antenna.
Steps for attaching and removing the belt clip accessory.
How to connect an external speaker or microphone.
Explanation of icons and indicators on the transceiver's LCD screen.
Detailed explanation of each numbered component on the transceiver.
Instructions for powering the transceiver on and off.
How to control the audio volume level.
Procedure to select the primary or secondary operating band.
How to toggle between channel memory and frequency tuning modes.
Steps to select or input a specific channel number.
Method for tuning to a specific frequency or adjusting frequency step.
How to scan for available FM radio stations.
How the transceiver indicates an incoming call or signal.
Basic procedure for sending a transmission.
Activating the emergency alarm feature.
Explains the programmable functions assigned to side keys.
How to use the Monitor key for squelch control and DTMF.
Setting frequency boundaries for VFO scanning.
How to access and control the built-in FM radio.
Configuring Continuous Tone-Coded Squelch System and Digital-Coded Squelch.
How to scan for CTCSS/DCS tones on a channel.
Configuring the frequency offset for repeater operations.
Initiating scans for frequencies or channels.
How to exclude specific channels from scanning.
Reversing the transmit and receive frequencies.
Adjusting the output power level for transmission.
Sending and checking DTMF codes.
How to lock and unlock the keypad to prevent accidental key presses.
How to operate in a single band (VHF or UHF) only.
How to enter and navigate the function menu to change settings.
How to configure different display modes (FREQ, CH, NAME).
Restoring the transceiver to its original factory settings.
To Next Page
