Need help?Do you have a question about the AnyTone Ares and is the answer not in the manual?
General| Bluetooth | No |
|---|---|
| GPS | No |
| Operating Modes | FM |
| Display | LCD |
| Waterproof | No |
Connect the microphone to the radio using the provided connector and pull the screw.
Install a high-efficiency CB antenna with 50-ohm impedance for optimal communication.
Connect the radio to a 13.8V power supply, avoiding 24V batteries or cigar lighter sockets.
Replace blown fuses with the specified 10A, 250V type to maintain radio operation.
Overview and identification of the radio's front panel controls and indicators.
Overview and identification of the radio's rear panel connectors and ports.
Details on the microphone components, including PTT, channel selection, and mic.
Instructions for turning the radio on and off using the volume control.
Adjusting the audio volume level during operation for optimal listening.
Adjusting the squelch level to minimize background noise.
Adjusting the microphone gain for clear transmission during transmit.
Adjusting the RF gain for optimal signal reception.
Selecting the operating mode: AM, FM, or PA.
Selecting the desired frequency band (A through F).
Adjusting the rebound times for the echo function.
Adjusting the duration of the echo effect.
Selecting the desired communication channel.
Operating the Noise Blanker and Automatic Noise Limiter functions.
Configuring high, super, or low RF power output for AM and FM modes.
Using the Monitor function or the +10KHz feature.
Adjusting the LED brightness to high, middle, or low levels.
Selecting frequency band groups or enabling the Weather channel function.
Technical details including frequency range, bands, channels, and dimensions.
Details on power output, modulation, and frequency response.
Details on sensitivity, selectivity, image rejection, and audio output.
To Next Page
