Why does my AnyTone Transceiver have a green light but no sound?
If your AnyTone Transceiver's receiving indicator shows a green light but you hear no sound, here's what to check: * First, make sure the volume isn't set too low by turning the volume knob clockwise to increase it. * If the volume is adequate, the loudspeaker, earphone jack, or volume switch might be broken. In such cases, it is suggested to contact local dealers for repair.
What to do if my AnyTone Transceiver is receiving intermittently with noise?
If your AnyTone Transceiver receives intermittently with a lot of noise, it could be due to a couple of reasons: * You might be out of the communication range or there might be obstructions like tall buildings, or you are in an area with significant noise. * Alternatively, the 450 filter might be broken. In both of these cases, it is suggested to contact local dealers for repair.
Why does my AnyTone Transceiver loudspeaker sound distorted?
If the loudspeaker on your AnyTone Transceiver becomes lower in volume or produces a “ka ka” sound after some use, it could be due to a broken loudspeaker, iron powder, or other debris inside the loudspeaker. It is suggested to contact local dealers for repair.
What to do if the receiving sound on my AnyTone Transceiver is low?
If the receiving sound on your AnyTone Transceiver gets low or intermittent, check if the MIC is obstructed. If not, it is suggested to contact your local dealers for repair.
Safety guidelines for handling, operation, and maintenance of the transceiver.
Setting the transceiver to operate as amateur or professional.
Guidelines and warnings for charging the transceiver battery.
Step-by-step instructions for charging the battery.
Explanation of charging status lights and troubleshooting indicators.
Explanation of icons and indicators on the transceiver's LCD screen.
How to turn the transceiver on/off and adjust audio volume.
Switching bands/modes and adjusting channels/frequencies.
Using squelch, and basic procedures for receiving/transmitting.
Resetting transceiver to factory default settings.
Instructions for installing and starting the programming software.
Detailed technical parameters for receiving and transmitting.
Solutions for frequent issues encountered with the transceiver.
General| Channel Capacity | 128 channels |
|---|---|
| Operating Voltage | 7.4V |
| Weight | 220g (with battery and antenna) |
| Waterproof Rating | IP54 |
| Display | LCD |
| Battery Capacity | 2000 mAh |
| Frequency Range | VHF: 136-174 MHz, UHF: 400-480MHz |
| Battery | Li-ion |
| Channel Spacing | 12.5 kHz / 25 kHz |
| Dimensions | 110mm x 58mm x 32mm |
To Next Page
