What to do if PTT key is pressed but transmission does not occur on AnyTone Radio?
If the PTT key is pressed but transmission doesn't occur on your AnyTone Radio, it could be due to a poor microphone or antenna connection. Ensure that both the microphone and antenna are properly connected.
Why no sound comes from speaker of AnyTone AT-588UV?
If no sound is coming from the speaker of your AnyTone Radio, it might be because the squelch is muted. Try decreasing the squelch level. Alternatively, Tone or CTCSS/DCS squelch may be active; try turning CTCSS or DCS squelch off.
What to do if rotating dial will not change memory channel on AnyTone AT-588UV?
If the rotating dial on your AnyTone Radio will not change the memory channel, it might be because the transceiver is in CALL mode. Press the VFO or memory mode to resolve this.
What to do if fuse is blown in AnyTone Radio?
To address a blown fuse in your AnyTone Radio, first check and solve the underlying problem that caused the fuse to blow. Then, replace the blown fuse with a new one.
Why nothing appears on display of AnyTone AT-588UV Radio?
If the power is on but nothing appears on the display of your AnyTone Radio, check the polarity of the power connection. Ensure that the red lead is connected to the plus terminal and the black lead to the minus terminal of the DC power supply.
General| Number of Channels | 200 |
|---|---|
| Operating Voltage | 13.8V DC ±15% |
| Operating Temperature | -20°C to +60°C |
| Frequency Stability | ±2.5 ppm |
| Modulation | FM |
| Weight | 1.2 kg |
| Antenna Impedance | 50Ω |
| Frequency Range | 136-174 MHz |
| Channel Spacing | 25 kHz / 12.5 kHz |
| Modulation Type | F3E |
| Current Consumption | ≤10A |
Instructions for safely mounting the transceiver in a vehicle.
Details the procedure for connecting the DC power cable to the transceiver.
Procedures for replacing blown fuses to maintain transceiver functionality.
Guidance on properly connecting an antenna for optimal performance.
Steps to connect the transceiver to a computer for software operations.
Steps to turn the transceiver on and off using the power switch.
How to control the audio output volume using the volume knob.
Procedure for switching between frequency (VFO) and channel modes.
Methods for adjusting the operating frequency using the selector knob or keypad.
How to select channels using the selector knob or keypad.
Instructions for switching the main and sub bands for dual receive.
How to select specific frequency bands for the left and right channels.
Steps and tips for transmitting, including microphone usage.
Lists common problems and their potential causes and solutions.
Details receiver sensitivity, selectivity, and audio characteristics per ETSI standards.
Details transmitter output power, modulation, and audio characteristics per ETSI standards.
To Next Page
