Why does my AnyTone Radio have no sound from the speaker?
If no sound is coming from the AnyTone Radio speaker, there might be a couple of reasons: * The squelch might be muted. Try decreasing the squelch level. * The CTCSS or DCS squelch might be active. Try turning CTCSS or DCS squelch off.
What to do if PTT key is pressed but transmission does not occur on AnyTone Dual Band FM Transceiver?
If you press the PTT key on your AnyTone Radio and transmission doesn't occur, it could be due to: * A poor microphone connection. Ensure the microphone is properly connected. * A poor antenna connection. Ensure the antenna is properly connected.
Why is my AnyTone Dual Band FM Transceiver Radio display blank when the power is on?
If your AnyTone Radio powers on but nothing appears on the display, check the power connection polarities. Ensure the red lead is connected to the plus terminal and the black lead to the minus terminal of the DC power supply.
What to do if key and dial do not function on AnyTone Dual Band FM Transceiver Radio?
If the key and dial on your AnyTone Radio do not function, the key-lock function may be activated. Try canceling the key-lock function.
How to fix a dim display on my AnyTone Dual Band FM Transceiver?
If the display on your AnyTone Radio is too dim, try adjusting the dimmer to a higher level.
General| Channel Capacity | 128 Channels |
|---|---|
| Operating Voltage | 7.4V DC |
| Frequency Stability | ±2.5 ppm |
| Operating Temperature | -20°C to +60°C |
| Battery | 7.4V 1800mAh Li-ion |
| Display | LCD |
| Channel Spacing | 12.5/25 kHz |
| Antenna Impedance | 50 Ohm |
| Modes of Operation | FM |
| Modulation | FM |
Steps for mounting the transceiver securely and safely in a vehicle.
Instructions for connecting the DC power cable to the vehicle battery and transceiver.
Guidance on using the transceiver with a 12V vehicle battery and power considerations.
Requirements for using the transceiver for fixed station operation.
Procedure for identifying and replacing blown fuses in the transceiver.
Guidance on connecting an efficient antenna for optimal performance.
Details on connecting external speakers and microphones.
Instructions for connecting the transceiver to a PC for software programming.
Procedure for powering the transceiver on and off.
How to adjust the audio volume for the selected band.
How to switch between frequency mode and channel mode.
Methods for adjusting the operating frequency using knobs or keys.
How to select and adjust channels using the selector knob.
How to switch the primary band for operation.
Procedure for selecting frequency bands for the left and right bands.
How the transceiver receives signals and displays status.
Steps and considerations for transmitting with the transceiver.
Adjusting the squelch level to filter unwanted signals.
Selecting the transmission power level for the current channel.
Monitoring two channels simultaneously.
Activating the emergency alarm function.
Scanning through frequencies or channels.
Performing a scan of programmed channels.
Editing and storing channel information.
Setting upper and lower limits for frequency scanning.
Copying channel data to another channel.
Automatically adjusting transmit frequency based on receive frequency.
Setting up CTCSS or DCS codes for encode operations.
Setting up CTCSS or DCS codes for decode operations.
Preventing transmission on a busy channel.
Enabling cross band repeater functionality.
Restoring all settings and channels to factory default.
Common problems and their potential causes and solutions.
To Next Page
