AOpen PV11a Series - OSD Menus (PV11;PV110;DP101;FG100); OSD Menu Navigation; USB Firmware Update

23
English
Onscreen Display (OSD) Menus (for PV11/
PV110/DP101/FG100)
Basic operations
1 After turning on the projector, the HDMI signal source displays if an
HDMI source is connected. If not, a "NO signal" message will display.
2Press (ENTER) or (Menu) and the OSD menus display.
3 Use / to select a main menu item.
4 Use / to select a sub menu item.
5 After selecting the desired item, press (ENTER) to enact it or enter
a submenu.
6 Use /// or (ENTER) to change the settings.
7 To exit the OSD menu, press (BACK) on the projector or remote control
repeatedly.
Channel
HDMI
Selects the HDMI source.
Software Update(USB)
You can follow below steps to update the firmware.
1 Download the latest version from website and
copy the file to a FAT32 formatted USB drive.
2 Power on the projector and plug in the USB flash
drive with the latest firmware files.
3 Go to the "Channel" > "Software Update(USB)"
menu and press "ENTER".
4 The confirmation message appears. Select "Yes"
and the update process will begin.