{figure 54}
The Name Edit screen will be displayed. Your desired text ident may now be
entered or edited. Use the [↑] and [↓] keys to select character line number, use the
main dial to move along each line, use the [←] and [→] keys to move along the
seven character text ident, use the [ENT] key to accept the input for each character.
Other options include Insert, Delete, Space and Quit. Refer to section 7 of this
manual for further details.
{figure 55}
B-5 Channel pass
Any memory channels which you would like to skip in program scan or manual
scan can be registered as a pass channel. Place the cursor “>” along side the Ch
Pass followed by [ENT], the ON/OFF legend will turn to negative image. Either
rotate the main dial or press the [←] or [→] keys to toggle the pass status ON/OFF.
Press the [ENT] key when the desired selection has been made.
{figure 56}
B-6 Delete
Place the cursor “>” along side Ch Delete followed by [ENT]. The currently displayed
memory contents will be completely erased in one go and cannot be restored
afterward.
{figure 57}
3.5.2 Copy
Press the [EDIT] key to select the memory function menu. While the “>” cursor is
along side the menu item “Ch Copy” press the [ENT] key. When Ch Copy is
selected the following screen will be displayed:-
{figure 58} {figure 59}
While in the Ch Copy menu, press the [↑] or [↓] key to move the red cursor “>” to the
position where you wish to copy the memory from (“Source”) and to (“Dist”) followed
by [ENT].
A Selection of original memory (source)
Press the [ENT] key when the cursor “>” is next to the “Source”. The line represents
CHANNEL (00 to 99) and BANK (00 to 14) numbers. The channel number will
reverse to a negative image to conform selection. Press the [←] or [→] keys to
toggle between channel number and bank number. Rotate the main dial to select the
desired channel number and bank number respectively followed by [ENT].
To Next Page
