AOR AR7000 - Channel Pass; Delete; Copy

{figure 60}
B Selection of distant memory (destination)
Press the [ENT] key when the cursor “>” is next to the “Dist”. The channel number of
the distant memory will reverse to a negative image. Press the [←] or [→] keys to
toggle between channel number and bank number. Rotate the main dial to select the
desired memory channel and bank number for the distant memory channel. Press
[ENT].
{figure 61}
C Executing copy
Now that both source memory and distant memory channel have been selected,
press the [↑] and [↓] keys to move the cursor “>” next to the legend “Copy” then
press [ENT]. The frequency and mode of the distant (destination) memory will
change to that of the source memory… both memory channels are now identical.
{figure 62}
D Exit from COPY
To return to the “Memory Function” menu, either press the [ESC] key or move the
cursor “>” to the “QUIT” legend then press [ENT], this terminates the copy session.
You are now back to the memory function menu.
{function 63}
3.5.3 Move
All the memory function menus manipulate in a similar manner. When the “Ch
Move” menu is selected via the memory function menu, the following screen will be
displayed:-
{figure 64} {figure 65}
Press the [↑] and [↓] keys to move the cursor “>” next to the legend “Ch Move” then
press [ENT].
A Selection of source memory channel
Press the [ENT] key when the cursor “>” is next to “Source”. The channel number
will reverse to a negative image to conform selection. Press the [←] or [→] keys to
toggle between channel number and bank number. Rotate the main dial to select the
desired channel number and bank number respectively followed by [ENT].
{figure 66}