B Selection of distant memory channel
Press the [ENT] key when the cursor “>” is next to “Dist”. The channel number of the
distant memory will reverse to a negative image. Press the [←] or [→] keys to toggle
between channel number and bank number. Rotate the main dial to select the
desired memory channel and bank number for the distant memory channel. Press
[ENT]
{figure 67}
C Executing the channel move
Now that both source memory and distant memory channel have been selected,
press the [↑] and [↓] keys to move the cursor “>” next to the legend “Move” then
press [ENT]. Memory contents will have been transferred to the distant channel,
and the source channel is now empty with no memory contents.
{figure 68}
D Exit from the memory channel move
To return to the “Memory Function” menu, either press the [ESC] key or move the
cursor “>” to the “QUIT” legend then press [ENT] to terminate the move session. You
are now back to the memory function menu.
{figure 69}
3.5.4 Swap
All the memory function menus manipulate in a similar manner. When the “Ch
Swap” menu is selected via the memory function menu, the following screen will be
displayed:-
{figure 70} {figure 71}
A Selection of source memory channel
Press the [ENT] key when the cursor “>” is next to “Source”. The channel number
will reverse to a negative image to conform selection. Press the [←] or [→] keys to
toggle between channel number and bank number. Rotate the main dial to select the
desired channel number and bank number respectively followed by [ENT].
{figure 72}
B Selection of distant memory channel
Press the [ENT] key when the cursor “>” is next to “Dist”. The channel number of the
distant memory will reverse to a negative image. Press the [←] or [→] keys to toggle
To Next Page
Loading...
