AP Diving AP50 - Cut the Convoluted Hose to the Desired Length; Push the Convoluted Hose Back Onto the Swivel Stem

AP Diving Ltd. Medium Pressure and Convoluted Hose Shortening Instructions
Page 35 of 38
7.5 Cut the convoluted hose to the desired length
- Preferably use a very sharp pair of scissors.
- Snip or cut into a valley of the convoluted hose, NOT into a rib.
CORRECT: cut into a valley WRONG: cut onto a rib
7.6 Push the convoluted hose back onto the swivel stem
- Push the hose STRAIGHT onto the swivel stem until the first convolution is AGAINST
the flange of the swivel stem. Try to avoid rotating the hose while doing this.
- Do NOT pull the convolution OVER the flange of the swivel stem (as you would do with
the new Ty-wrap type of convoluted hose ends, as described in chapter 6).