Apache Labs ANAN-100/D
Click on the “SETUP” menu selection to configure the P*SDR software.
P*SDR basic display screen
Go to GENERAL Hardware Configuration tab and not→ → e the IP Address and MAC address that are read from
the ANAN-100/D Transceiver.
Note: if the IP ADDRESS is 0.0.0.0
you must check your LAN connection.
P*SDR/OpenHPSDR software has not been started
Power button on the rig has not been activated
Also check your LAN connector on the ANAN-100/D to insure that the Link Light on the LEFT side of the LAN
connector is illuminated.
Revision v1.8 April 23, 2013 21 of 70 authors N9VV and KC9XG
To Next Page
Loading...
