Apache Labs ANAN-100/D
Setup ---> General tab ---> Hardware Config tab, the Radio Model should have ANAN-100/D selected.
Connection Type “ANAN” and “Full Network Discovery” should both be checked. In the “Region, select the
Country in which you reside.
The ANAN IP address and Firmware version number in the green box highlighted above will be set
automatically by your network router DHCP server, or if connected directly to your PC, the IP address will be
assigned by the “APIPA” process – WHICH MAY TAKE UP TO SEVERAL MINUTES TO ASSIGN AN IP ADDRESS.
If your LAN is properly configured, the ANAN-100/D board IP ADDRESS and MAC ADDRESS should be
automatically be detected and assigned. An incorrect default value is 169.254.1XX.XXX. P*SDR™ will display
the currently assigned IP address and MAC address of the ANAN-100/D Hermes board if the LAN connection
is properly connected and configured. If the ANAN-100/D IP ADDRESS remains 0.0.0.0 then you must
determine if P*SDR and your PC network connection is operating correctly. Some typical problems could be
that the Ethernet connection to your PC or LAN connector is disabled in Windows. The Ethernet connector
may not be properly seated in your PC or Router. DHCP addressing must be properly enabled on your router.
The new HPSDRProgrammer V2 utility allows you to assign a STATIC IP ADDRESS if you wish.
Please see APIPA appendix on page 67 of this document for more information.
Revision v1.8 April 23, 2013 23 of 70 authors N9VV and KC9XG
To Next Page
Loading...
