Apache Labs ANAN-100/D - ANAN-100;D Rear Panel Connections

Apache Labs ANAN-100/D
ANAN-100/D Rear Panel connections
Author William Diaz KC9XG
ANAN-100/D Antenna connections as shown on 100W_Rev15A.pdf and as built on the back panel.
100W_Rev15A.pdf connector labels differ considerably from the ANAN-100/D back panel labels.
100W_Rev15A.pdf shows 2 separate RX2 in connectors, but they are, in fact, different as indicated by the
underline.
Schematic
October 12, 2012
ANAN-100/ D
back panel
Hermes board Angelia board PA FILTER
BOARD
Rx_Master_In (LPF) NC, Internal only NC
To_RX (HPF) NC
RX1_In RX1_In J13
TX IN
TX Out TX Out J2
3.5mm audio
Balanced Speaker
Output
1/8” 3.5mm stereo
jack
J16-14
and
J16-15
J16-14
and
J16-15
PTT-IN Accessory port
DB25-13
J16-1 J16-1
PTT-OUT Accessory port
DB25-1
RCA Jack on back
panel
J16-25 J16-25
XVTR-TX
TX-in J3 (ØdBm)
Schematic
October 12, 2012
ANAN-100/ D
back panel
Hermes board Angelia board PA FILTER
BOARD
RX2 IN (No
underline)
RX2 (BNC) NC RX2 IN J10
ANT1, ANT2, ANT3 ANT1, ANT2, ANT3
(BNC)
J4, J5, J6
Rx_Bypass_Out Bypass (BNC)
J18
Rx2_In EXT1 (BNC)
J15
XVTR Rx In XVTR RX (BNC)
J14
Rx3_In EXT2 (BNC)
J16
SEE NOTES BELOW:
Default RX1 Receive Signal path from ANT(n) is ANT(n), LPF, HPF, Hermes/Angelia receiver 1.
Default Transmit signal path from Hermes/Angelia TX-Out is Tx IN, HF TX, LPF, Ant(n).
One connector must be selected from ANT1, ANT2, or ANT3. Default is ANT1
Only one connector can be selected from Ext1, Ext2, or XVrtr RX. Default is none active.
RX_Bypass_Out is optionally used with an external filter or pre-amp connected between Bypass and selected
Revision v1.8 April 23, 2013 43 of 70 authors N9VV and KC9XG