Apache Labs ANAN-100/D
Troubleshooting symptom, no transmit audio.
1. Mic is disabled by default when VAC1 is enabled.
A. Setup, audio tab has check boxes for enabling PTT etc, while VAC is active.
B. Alternately, disable VAC when transmitting with the mic.
Trouble shooting Power Output.
1. Ensure Driver level is set to a non-zero value.
2. If the "TUNE" button has insufficient output to activate auto-tuners"
A. Menu selection, "Setup", "Transmit" tab, increase "Tune" "Power (W)" value.
3. If external autotuner seems to give erratic results, try unchecking "Enable Protection" on "Setup",
"Ant/Filters" tab.
Revision v1.8 April 23, 2013 46 of 70 authors N9VV and KC9XG
To Next Page
Loading...
