24
4.0 Installation
4.10 Module interconnections
Follow the instructions listed below to install and lock the battery couplers.
4.10.1 Using a phillips screwdriver, remove the battery coupler clamps from the
Electronics Unit and from all but one Battery Pack.
4.10.2 Turn the battery coupler clamp over and fasten loosely to one side.
4.10.3 Connect the battery couplers as shown in the figure below.
4.10.4 Fasten the other side of the battery coupler clamp to secure couplers.
Note: To reduce the risk of
toppling, do not stack
equipment more than 2
units high.
Remove clamp Turn clamp Mate couplers Secure clamp
Typical installation showing mated battery couplers.
To Next Page
Loading...