APC Smart-UPS RT User Manual

1
Introduction
The APC Smart-UPS® RT is a high-performance, uninterruptible power supply (UPS) that provides
protection for electronic equipment from utility power blackouts, brownouts, sags and surges. The
UPS filters small utility line fluctuations and isolates electronic equipment from large disturbances
by internally disconnecting from utility line power. The UPS provides continuous power from the
internal battery until utility power returns to safe levels or the battery is fully discharged.
INSTALLATION
Read the safety information sheet before installation.
Unpacking
Inspect the UPS upon receipt. Notify the carrier
and dealer if there is damage.
The packaging is recyclable; save it for reuse or
dispose of it properly.
Check the package contents:
 UPS (with batteries disconnected)
 Two front bezels
 Literature kit containing:
 XLT/XLTW models only: Software CD
 Smart-UPS User Manuals CD
 XLI model only: Six output power cords
 Serial cable
 Product documentation, safety and
warranty information
 Network Management Card
documentation
Removing the Batteries
The unit is heavy. To lighten the unit, remove the batteries. Refer to the unpacking instructions on
the carton in which the unit is shipped.
Specifications
TEMPERATURE
OPERATING
S
TORAGE
32° to 104° F (0° to 40° C)
5° to 113° F (-15 to 45 ° C) charge UPS battery every six months
MAXIMUM
ELEVATION
OPERATING
S
TORAGE
10,000 ft (3,000 m)
50,000 ft (15,000 m)
HUMIDITY 0% to 95% relative humidity, non-condensing
This unit is intended for
indoor use only. Select a
location sturdy enough to
handle the weight.
Do not operate the UPS where
there is excessive dust or the
temperature and humidity are
outside the specified limits.
Ensure the air vents on the
front and rear of the UPS
are not blocked.
WEIGHT
UPS
UPS
WITH
PACKAGING
244 lbs (111 kg)
284 lbs (129 kg)

APC Smart-UPS RT Specifications

General

Noise level	55 dB
Output power	3500 W
Surge energy rating	480 J
Output power capacity	5 kVA
Emergency Power Off (EPO)	Yes
I/O ports	DB-9 RS-232
Dimensions (WxDxH)	130 x 660 x 432 mm
Output voltage note	230 - 240
Nominal input voltage	230 V
Battery technology	Sealed Lead Acid (VRLA)
Battery recharge time	2.5 h
Typical backup time at full load	5 min
Typical backup time at half load	15.4 min
Ethernet LAN (RJ-45) ports	1
Number of output IEC jumpers	6
Certification	C-tick, CE, EN 50091-1, EN 50091-2, EN 55022 Class A, N 60950, EN 61000-3-2, GOST, VDE
Product color	Black
Operating altitude	0 - 3000 m
Non-operating altitude	0 - 15000 m
Storage temperature (T-T)	-15 - 45 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %

Weight and Dimensions

Weight	54550 g