Need help?Do you have a question about the APC Smart-UPS RC and is the answer not in the manual?
General| Nominal Output Voltage | 230V |
|---|---|
| Nominal Input Voltage | 230V |
| Typical Recharge Time | 3 hours |
| Interface Port(s) | SmartSlot, USB |
| Type | Line Interactive |
| Input Voltage Range | 160 - 286V |
| Output Voltage | 230V |
| Form Factor | Tower |
| Battery Type | Maintenance-free sealed Lead-Acid battery with suspended electrolyte |
| Output Connections | IEC 320 C13 |
| Frequency | 50/60 Hz +/- 3 Hz |
| Communication Ports | USB |
| Input Connections | IEC-320 C14 |
Describes the APC Smart-UPS RC as a high-performance UPS for protection against power disturbances.
Instructions on inspecting and checking the contents of the UPS package.
Lists and illustrates hardware provided for rack-mount and tower configurations.
Information on optional accessories like external battery packs and rail kits.
Details operating and storage temperature, maximum elevation, and humidity limits.
Provides weight and dimension details for the UPS unit.
Describes the front panel layout and components of the UPS.
Details the various ports and connectors found on the rear panel of the UPS.
Important precautions and general guidelines before installing the UPS unit.
Instructions on how to remove the battery compartment door for tower and rack configurations.
Guide on installing stabilizer brackets for the tower configuration.
Instructions for locating and installing the UPS display panel.
Steps to remove and reposition the display panel for rack mounting.
Guidance on safely positioning the heavy UPS unit for rack installation.
Instructions for attaching the rack-mount brackets to the UPS unit.
Guidelines for connecting external equipment and battery packs to the UPS.
Instructions on how to start the UPS and initial battery charging.
Explains the indicators and their meanings on the UPS front panel.
Details the functions of the buttons on the UPS front panel (Test, Off).
Lists and describes various UPS settings adjustable via software or accessory cards.
Allows user to select output voltage while on-line.
Sets allowable UPS output frequency, tracking input frequency when possible.
Defines the number of connected battery strings for proper run time prediction.
Instructions for connecting the EPO interface to external switches.
Refers to the user manual for external battery pack installation instructions.
Solutions for UPS not turning on or not turning off.
Explains occasional beeps, sequential LED flashing, and no LEDs illuminated.
Addresses insufficient backup time, Bypass/Overload LEDs, and Fault LED.
Details bypass/overload conditions and battery fault indicators.
Addresses circuit breaker trips, no utility power, and voltage problems.
Explains diagnostic utility voltage and On Line LED status.
Procedure for replacing the hot-swappable battery module.
Steps to safely shut down and prepare the UPS for shipping.
States compliance with EN62040-2 Class A requirements and conditions.
Steps to take when service is required, including contacting support.
Guidelines for packing the UPS properly for transit.
Information on how to access customer support via web, phone, or email.
Outlines the warranty period and conditions for APC products.
Details warranty exclusions, disclaimers, and liability limitations.
Instructions on how to submit warranty claims and find regional support.
To Next Page