2021.08.19 REV. PRESSURE CONTROLLER OPERATING MANUAL 5
Quick Start Guide
Setup
• Connect your pressure controller. Ensure
that flow will pass through your device in the
same direction as the arrow on the flow body
(usually left to right).
•
Choose your engineering units. You can
choose the measurement units by selecting
MAIN MENU
→
SETUP
→
Sensor
→
Engineering
Units (page 17).
Operation: Pressure Verification
Monitor live pressure readings. Readings are
updated and displayed on your device in real
time (page 11).
Connectors and Buttons
The drawing to the right represents a typical
configuration of a standard pressure controller.
Your pressure controller’s appearance and
connections may differ (page 16).
Backlight
The monochrome display comes equipped with
a backlight. To toggle the backlight power,
press the bottom button on the front of your
device.
For optional color TFT displays, pressing this
button will turn o the display to conserve power.
See page 11.
Maintenance and Care
• Pressure controllers do not require cleaning
when flowing clean, dry gases (page 24).
• Calibrate your device annually. To schedule
a calibration, please contact support
(page 16).
This is a typical gauge
pressure configuration.
This is a typical differential
pressure configuration.
To Next Page
Loading...