Apexis IP Wireless / Wired Camera - 3.16 Mail Service Settings

 MoreSecurity,MoreConveniencewww.apexis.com.cn/www.apexis.cc
FTP Upload, Alarm Mail Alert, Record Path etc.
3.16 Mail Service Settings
Set Mail Service Settings to enable the camera send email alert when motion detection triggered.
Figure 9.1
Sender: Make sure the sender mailbox server provider support SMTP, and the mailbox should not enable SSL
or TSL encryption too.
Receiver: Here you can set four receivers. For receiver, there is no SMTP limitation.
SMTP Server: The sender’s SMTP Server.
SMTP Port: The sender’s SMTP Port, usually is 25, some SMTP server have its own port such as 587.
Need Authentication: If there is SMTP user & password, please select authentication.
SMTP User: Input correct SMTP User here. Some SMTP User is the sender’s full email address, such as
test@qq.com, some are without suffix, only the username, such as test.
SMTP Password: Input correct SMTP password here.
NOTE: Please click Submit firstly before choosing Test.
You will see the test result after click Test.
Figure 9.2
Shenzhen Apexis Electronic Co., Ltd Tel: +86-755-26509025 Fax: +86-755-26509229
41