Need help?Do you have a question about the Apexis IP Wireless / Wired Camera and is the answer not in the manual?
General| Connectivity | Wireless / Wired |
|---|---|
| Category | Security Camera |
| Motion Detection | Yes |
| Type | IP Camera |
| Night Vision | Yes |
Provides step-by-step guidance for setting up the camera hardware, including antenna, power, and network cable.
Explains how to install the IP Camera Tool and ActiveX components for proper camera operation.
Describes the function and usage of the IP Camera Tool software for finding and managing cameras.
Details how to configure network parameters like IP address, subnet mask, and gateway.
How to configure the camera to view multiple devices (up to 9) simultaneously.
Step-by-step guide to add multiple cameras within the local network for monitoring.
Instructions to set up multi-device viewing over the internet using DDNS domain names.
How to reset all camera settings to their default factory values and reboot.
How to manually set the camera's IP address, subnet mask, and gateway.
Instructions for connecting the camera to a wireless network by scanning and selecting an SSID.
How to configure Dynamic DNS services for remote access to the camera.
How to back up current camera settings and restore them from a saved file.
How to configure email alerts for events like motion detection, including sender and receiver details.
How to set up FTP for uploading images or files upon motion detection.
How to configure alarm functions, including motion detection and external inputs.
How to enable and configure motion detection alarms, including sound and recording.
How to adjust the sensitivity level for motion detection from 1 to 10.
How to configure the camera to send email alerts with snapshots upon alarm triggers.
Common questions and troubleshooting tips for camera setup and operation.
Steps to reset forgotten administrator username and password to factory defaults.
Troubleshooting common reasons for not being able to access the camera over the internet.
Troubleshooting steps when the IP Camera Tool fails to detect the camera on the network.
To Next Page
