What to do if my Appotronics Projector has no picture?
If your Appotronics Projector shows no picture, first ensure the video signal source is enabled and properly connected. Also, verify that the projector and the input signal device are correctly connected. Finally, select the correct input signal source using the signal source key on the projector or remote control.
How to fix Appotronics AL-UK535A Projector that fails to power on?
If your Appotronics Projector fails to power on, make sure the power cable is properly connected to both the projector's AC port and the electrical outlet. If the outlet has a switch, ensure it is turned on.
What to do if Appotronics AL-UK535A remote control fails?
If your Appotronics Projector remote control fails, first replace the battery. If that doesn't work, make sure there are no obstacles between the remote control and the projector. Also, ensure that you are no further than 5 meters (16 inches) away from the projector.
General| Projection Technology | DLP |
|---|---|
| Light Source | Laser |
| Projection Size | 300 inches |
| Aspect Ratio | 16:9 |
| Keystone Correction | Vertical ±40° |
| Operating Temperature | 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 10% to 85% (non-condensing) |
| Input Ports | HDMI, VGA, USB, RS232, Audio In |
| Output Ports | Audio Out |
To Next Page
