Step 4: Level the Table
Tools Required: Leg Wrench
¾-inch Open-End Wrench or Crescent Wrench
Long Level
For optimum movement, the table should be level both left-to-right and front-to-back. (Bliss Table Owners—see the
special note at the end of this section.) You can adjust each leg independently to get the table as close to level as possible.
While this section describes the leveling process, you can also use it to adjust the table’s working height. The leg
extensions allow 9 inches of upward adjustment.
1. Move the table close to its final location
2. Place a level across the two rails near the end of the table (parallel to the leg). Adjust legs as described below.
1. To adjust the leg levelers,
loosen the large jam nut
directly underneath the
leg with the leg wrench.
2. Place a ¾ - inch open-end wrench
(or crescent wrench) on the foot
pad nut. Turn the nut clockwise
to lower the leg;
counterclockwise will raise the
leg.
3. When the table is level in
all directions, tighten the
jam nut against the top of
the leg with the leg
wrench.
To Next Page