Install the Fabric Clamps
1. Attach each velco strap
with buckle (JJ) to the
loop tape that is pre-
installed on each leg.
2. The buckle should be on the
outside of the leg, the the
lever should open “up”.
3. Unroll clamp with elastic (II).
Hold the clamp so the side
with the elastic attached is
facing the floor.
4. Raise the buckle lever
and slide the elastic end
into it as shown above.
5. Pull the elastic through to
the desired length for your
quilt.
6. Push the lever down to hold
the elastic in position.
To Next Page