Threading Your Machine
1. Place your thread cone on the thread stand, pull thread tail through the large wire thread
guide (this guide should be centered directly over the thread cone).
2. Place a small piece of batting in your wire thread guide, place thread under the batting (not
through it) to prevent the thread from jumping off the spool or puddling on the bottom of the
spool holder.
3. IF you have a Thread Break Sensor, thread the
three-hole thread guide directly below the
Thread Break Sensor Wheel, spiraling around
the vertical three-hole thread guide.
4. IF you DO NOT have a Thread Break
Sensor, place thread in any hole to pass
through once.
To Next Page
Loading...