Using a 7/16” wrench, loosen the gold mounting bolt that holds the encoder on the carriage axle. You don’t
have much room to work, but once the encoder box starts to spin, then you can swivel it out of the way so
you have more room to access the bolt.
Once the encoder box is loose, push it closer to the table…this will move the encoder wheel in tighter to the
carriage wheel.
Once the position is set, then tighten the gold mounting bolt again, holding the encoder box in place. Check
the encoder wheel positioning before tightening the bolt completely.
Mounting bolt for carriage encoder box
Loosen mounting bolt with 7/16” wrench
Push box closer to table and hold in
place while tightening the bolt
To Next Page
Loading...